Philips AJT5300 Quick Start Manual

Always there to help you
Register your product and get support at
AJT5300
www.philips.com/support
Question? Question?
Contact Contact
Philips Philips
Quick start guide
Specifications are subject to change without notice.
This product has been manufactured by, and is sold
under the responsibility of Gibson Innovations Ltd.,
and Gibson Innovations Ltd. is the warrantor in
relation to this product.
Philips and the Philips Shield Emblem are registered
trademarks of Koninklijke Philips N.V. and are used
under license.
AJT5300_79_QSG_V3.0
SOURCE
FM
1
Fully extend and adjust the position of the pig-tail
antenna until you find the best reception.
2
Fix the antenna as illustrated.
SOURCE
2 sec.
Note:
• If you cannot find [Philips AJT5300] for pairing, press and hold
pairing mode, and then try again.
AJT5300_79_QSG_V3.0.indd 1
Always there to help you
Register your product and get support at
www.philips.com/support
Question?
Contact
Philips
Quick Start Guide
FM BT
AUX
(Standby)
Note: You can only set time in standby mode.
Tune to FM radio stations
SOURCE SOURCE
TUNE TUNE
Philips AJT5300
for two seconds to enter
Note:
• You can only use AC power as power supply.
The battery can only back up clock and alarm
settings.
2 AA
STANDBY
Store radio stations automatically
SOURCE
SCAN
Store radio stations manually Select a preset radio station
SOURCE
TUNE
TUNE
After Bluetooth connection, you can control your incoming phone call with this product.
Button Function
Press to answer an incoming call.
During a call, press to end the current call.
Press and hold to reject an incoming call.
AL1 AL2
2017/6/29 10:13:19