Table of Contents
Advertisement
4. assembLy anD PreParation
Unpack contents and check to ensure all parts are in good condition. If you experience any
problems contact your stockist immediately.
4.1.
WheeL assembLy fig.2
note:
Make sure that there is enough air in wheel before assembly.
4.1.1.
lift the frame (fig.2.A) with one hand and attach one of the wheels (fig.2.B) by pressing the
wheel's pin and inserting the wheel shaft into the main frame (fig.2.A). Align the pin with the
hole on the frame (fig.2.A) until it snaps in. Repeat it for the opposite side.
4.2.
frame assembLy fig.3
4.2.1.
Place the handle assembly flat onto the main frame. Attach handle assembly to frame through
square neck bolt. Screw the knob on from outside of the frame. Handles can be folded forward
for storage (fig.3)
4.3.
hose hooK assembLy fig.5
4.3.1.
Attach the hose hook (fig.5.H) to the back of the panel until it slides into place.
fig.3
fig.6
4.4.
gun hoLster assembLy fig.4
4.4.1.
Attach the gun holster (fig.4.C.G) to the frame side, slide down into place.
4.5.
hose ConneCtions fig.7
4.5.1.
detach the quick connector from pump water inlet and screw it to a garden
hose. Then attach them to the pump water inlet.
4.6.
gun & WanD assembLy fig.7
4.6.1.
Assemble the spray gun with the metal wand. Pull back the rubber piece
to expose the threaded fitting. Then, screw the two pieces together and
move the rubber piece back.
4.6.2.
Insert the desired tip to the gun tip connector.
4.7.
gun & hose ConneCtions fig.7
4.7.1.
Take out transit plug from pump outlet. Connect one end of the high
pressure hose to pump outlet, and secure the plastic nut. Connect the
other end the pressure gun, and fasten the plastic nut.
4.7.2.
Connect the mains water supply hose to the pump inlet as shown in fig.8.
use CoLD Water onLy.
note:
The water supply hose must be reinforced and have an internal diameter
of 13mm (1/2"). The minimum water supply rate must be at least equal to
the washer flow rate.
4.8.
Water suCtion hose
4.8.1.
Attach suction hose to water inlet on pump.
4.8.2.
Put the filter inlet into the water supply.
4.8.3.
Make sure high pressure hose and suction hose are properly connected
before starting the pressure washer.
© Jack Sealey limited
fig.4
Original Language Version
fig.2
fig.5
fig.7
PWM2500SP.V2 Issue 1 02/12/19
Advertisement
Table of Contents
