Time Code - JVC GR-DV L155 Instructions Manual

18
EN

Time Code

During recording, a time code is recorded on the tape. This code is to confirm the location of the recorded
scene on the tape during playback.
If recording starts from a blank portion, the time code begins counting from "00:00:00"
(minute:second:frame). If recording starts from the end of a previously recorded scene, the time code
continues from the last time code number.
To perform Random Assemble Editing (
portion is left partway through the tape, the time code is interrupted. When recording is resumed, the time
code starts counting up again from "00:00:00". This means the camcorder may record the same time codes
as those existing in a previously recorded scene. To prevent this, perform "Recording From The Middle of A
Tape" below in the following cases;
• When shooting again after playing back a
recorded tape.
• When power shuts off during shooting.
• When a tape is removed and re-inserted during
shooting.
• When shooting using a partially recorded tape.
• When shooting on a blank portion located
partway through the tape.
• When shooting again after shooting a scene
then opening/closing the cassette holder cover.
Recording From The M iddle Of A Tape
1. Play back a tape or use Blank Search (
then engage the Still Playback mode (
2. Set the Power Switch to "
then start recording.
N O TES:
● The time code cannot be reset.
● During fast-forwarding and rewinding, the time code indication does not move smoothly.
● The time code is displayed only when "TIME CODE" is set to "ON" (
When a blank portion is recorded on a tape
Time code
00:00:00
Tape
Shooting start point
Proper recording
Time code
00:00:00
Tape
Shooting start point
Downloaded from:
" or "
Already recorded scene
Shooting stop point
Already recorded scene
Shooting start point
https://www.usersmanualguide.com/
pg. 43 – 47), time code is necessary. If during recording a blank
Display
12 : 34 : 24
pg. 22) to find the spot at which you want to start recording,
pg. 19).
" while pressing down the Lock Button located on the switch,
Time code Time code
05:43:21 00:00:00
Blank
Shooting start point
Time code Time code
05:43:21 05:44:00
New scene
Shooting start point
RECORDING
Frames are not displayed
during recording.
Minutes
Seconds
Frames
(25 frames = 1 second)
pg. 35, 36).
Newly recorded scene
Latest scene
(cont. )