Table of Contents
Advertisement
Omitting the final spin (Rinse
hold)
Select the
Rinse hold
If Rinse hold is selected, the laundry re-
mains in the water following the final
rinse cycle. This helps to prevent creas-
ing if the laundry is not going to be re-
moved from the drum immediately after
the end of the programme.
Ending a programme with a spin
cycle
The wash programme is set to the op-
timum spin speed. You can change the
spin speed.
Touch the
Change spin speed
control.
Select the desired spin speed.
Touch the Start/Stop sensor control
to start the final spin.
Ending a programme without a spin
cycle
Touch the
Change spin speed
control.
Select Spin speed
Touch the Start/Stop sensor control.
Extra.
sensor
sensor
0 rpm
(no spin).
Interim spin
There is a spin cycle after the main
wash and between the rinses. A reduc-
tion in the final spin speed will also re-
duce the interim spin speed as appro-
priate.
Omitting the interim spin and
the final spin
Touch the
Spin speed
Select the
0 rpm
After the last rinse, the water will be
pumped away and the anti-crease
phase will switch in.
In some programmes an additional rinse
is introduced with this setting.
Spinning
sensor.
setting.
43
Advertisement
Table of Contents
