Table of Contents
Advertisement
SCSI Enable/Disable
(6123L-8R only)
The SCSI jumper at JA1 allows you to
enable or disable the onboard SCSI
controller. The normal (default) posi-
tion is on pins 1-2 to enable SCSI ter-
mination. See the table on the right
for jumper settings.
5-10 Onboard Indicators
GLAN LEDs
Each of the Gigabit Ethernet LAN
ports (located beside the COM2 port
on the back panel) has two LEDs.
The yellow LED indicates activity
while the other LED may be green,
orange or off to indicate the speed of
the connection. See the table at right
for the functions associated with the
second LED.
Debug LEDs
There are two debug LEDs located
next to the IDE 2 Connector to indi-
cate common debug messages.
See the table below for the functions
associated with the debug LEDs.
Chapter 5: Advanced Serverboard Setup
Debug LED Indications
(DS3, DS4)
DS3 DS4
Indication
On
On
SNC found and start memory sizing
Off
On
Initial system memory and SIOH
On
Off
Valid memory and SIOH found
Off
Off
ICH4 found
5-25
SCSI Enable/Disable
Jumper Settings
(JA1)
Jumper
Position
Definition
Pins 1-2
Enabled
Pins 2-3
Disabled
Gb LAN Right LED
Indicator
LED
Color
Definition
Off
No Connection
Green
100 Mb
Orange
1 Gb
Advertisement
Table of Contents
