Watch Dog Enable/Disable; Lan1/2 Enable/Disable; I C To Pci Enable/Disable; Vga Enable/Disable - Supero SuperServer 6024H-32 User Manual

S S
UPER ERVER 6024H-32R/6024H-32 User's Manual

Watch Dog Enable/Disable

JWD enables the Watch Dog function,
a system monitor that takes action
when a software application freezes
the system. Jumping pins 1-2 will
have WD reboot the system if a pro-
gram freezes. Jumping pins 2-3 will
generate a non-maskable interrupt for
the program that has frozen. See the
table on the right for jumper settings.
Watch Dog must also be enabled in
BIOS.

LAN1/2 Enable/Disable

Use JPL1 and JPL2 to enable or
disable the LAN1 and LAN2 ports,
respectively. See the table on the
right for jumper settings. The default
setting is enabled.
I 2 C to PCI Enable/Disable
The JI 2 C1/2 pair of jumpers allow you
to connect the System Management
Bus to the PCI slots. The default set-
ting is closed for both jumpers to en-
able the connection. Both connectors
must have the same setting (JI
2
for data and JI C2 is for the clock). See
the table on right for jumper settings.

VGA Enable/Disable

JPG1 allows you to enable or disable
the VGA port. The default position is
on pins 1 and 2 to enable VGA. See
the table on the right for jumper set-
tings.
Jumper Settings (JWD)
Jumper Setting
Pins 1-2
Pins 2-3
Open
Note: when Watch Dog is enabled, the user must
write their own application software to disable the
Watch Dog Timer.
LAN1/2 Enable/Disable
Jumper Settings (JPL1/JPL2)
Jumper Setting
Pins 1-2
Pins 2-3
I 2 C to PCI Enable/Disable
Jumper Setting
Closed
Open
2 C1 is
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting
Pins 1-2
Pins 2-3
5-20
Watch Dog
Defi nition
Reset
NMI
Disabled
Defi nition
Enabled
Disabled
Jumper Settings
(JI 2 C1/2)
Defi nition
Enabled
Disabled
Defi nition
Enabled
Disabled