Asko D5457 Operating Instructions Manual page 9

Time remaining
Once you have selected a program and options, the display
indicates how long the program took the last time it was used.
Once you have started the dishwasher, the display indicates how
much program time remains. The remaining time is updated after
the water for the final rinse has been heated.
This may differ somewhat from time to time depending on the
temperature of the water supply, the amount of dishes, the
ambient temperature and other factors.
The time counts down while the program is running and the
remainder of the program is displayed. The remaining time is
displayed e.g. 1:15, meaning that 1 minute 15 seconds of the
program remains.
NOTE!
During the first run of each program, the remaining time
displayed can be slightly misleading, as the dishwasher is
estimating the time. When you run the program a second time,
the dishwasher will calculate the remaining time based on the
previous duration of the program.
Stopping or changing a program
In order not to accidently press a button and cancel the current
program, you must press and hold Start/Stop for five seconds if
you want to change programs after starting the dishwasher. Add
more detergent if the lid of the detergent dispenser has opened.
Then choose a new program and press Start/Stop.
Do you want to add more dishes?
Open the door. The dishwasher stops automatically. Add the
dishes, close the door and the dishwasher continues the program.
If the dishwasher is turned off using
the main power switch or due to a
power failure
If the dishwashing program was not finished, the interrupted
program continues when power is restored.
NOTE!
During drying, the program is interrupted if the power is cut or
the door is open for more than 2 minutes.
Once the program has finished
Once the program has finished, "End" appears on the display.
A buzzer also sounds at the end of the program. See the section
Settings, which describes how to change this function.
Once the dishwasher has finished, it uses only standby power.
Turn off the dishwasher using the main power switch if you want
to completely cut the power. Turn off the water supply valve after
each use.
Drying
For additional drying the door should be opened 35 mm upon
completion of the drying cycle. For more information, see page
17 in the chapter Technical information.
9