Tools, Supplies, And Required Equipment - Traxxas 1/16 SLASH 4x4 Manual

TOOLS, SUPPLIES, AND REQUIRED EQUIPMENT

Your model comes with a set of specialty metric tools. You'll need to purchase other items, available from your hobby dealer, to operate and
maintain your model.
SUPPLIED TOOLS AND EQUIPMENT
1.5mm "L" wrench 2.0mm "T" wrench
6-cell 2/3A iD NiMH battery
DECORATING YOUR MODEL
APPLYING THE DECALS
The main decals for your model
have been applied at the factory.
Additional decals are printed on
self-adhesive clear mylar and are
die-cut for easy removal. Use a
hobby knife to lift the corner of a
decal and lift it from the backing.
To apply the decals, place one end
down, hold the other end up, and
gradually smooth the decal down
with your finger as you go. This will
prevent air bubbles. Placing both
ends of the decal down and then
trying to smooth it out will result in
air pockets.
Look at the photos on the box for
typical decal placement.
2.5mm ball driver wrench
NiMH battery charger with iD Body clips
REQUIRED EQUIPMENT
(sold separately)
4-way wrench
For more information on
batteries, see Use the Right
Batteries on page 13.
4 AA alkaline
Recommended Equipment
batteries These items are not required
for the operation of your
model, but are a good idea to
include in any R/C toolbox:
• Safety glasses
• Traxxas Ultra Premium Tire
USB-C power
Glue, Part #6468 (CA glue)
adapter and
• Hobby knife
cable
• Side cutters and/or needle
nose pliers
• Phillips screwdriver
• Soldering iron
9 9
1/16 SLASH 4WD • 7