Assembly - Breville AquaStation Hot Instruction Book

Assembly

BEFORE FIRST USE
• Remove and safely discard any packaging
material or promotional labels attached to
your unit and filter. Check for any missing or
damaged parts as per the components list.
NOTE
As an important part of our quality control
process, your unit has been individually tested.
As a result, you may notice a small amount of
condensation or water droplets on the inside
of the water tank. There is no need for concern.
Please remove and discard the red silicone
rubber cap off the spout before use.
• Remove the Activ360™ 4-Stage filter from the
water tank and set aside.
• Do not wash the filter or insert into the
upper water tank until 'Flushing the Breville
AquaStation' and 'Preparing the Activ360
Filter' instructions are completed as found in
this book.
• Place the unit on a dry, flat level surface.
• Wash the water tank lid, upper (pre-filtered)
water tank, lower (filtered) water tank in warm
soapy water with a soft, non-abrasive cloth.
Rinse and dry thoroughly with a clean, soft,
lint-free cloth and return to the .
• Assemble the water tank back onto the power
base.
• Plug the power plug into a 230/240V power
outlet and turn on the power outlet.
IMPORTANT
When moving the water , always lift from the
base using two hands and set down gently on a
flat and level surface.
FLUSHING THE BREVILLE
AQUASTATION
It is important to flush and rinse the dispensing
system before using the unit for the first time.
Before first use, it is recommended to carry out
the below steps without the Activ360™ Water
Filter in place.
1. Fit only the larger lower (filtered) water tank
into place on the base of the with the lid
removed.
2. Fill the lower tank with cold tap water to the
MAX level. Never fill past the MAX level.
3. Place a 1L container under the dispensing
spout
4. Press the START/STOP
start dispensing ambient water until the
container is full, then press the START/
STOP button once again to stop
dispensing. Discard the collected water.
5. Repeat steps 3-5 until all the water in the
lower tank has been dispensed. The unit
will stop dispensing automatically when the
water level is too low or automatically after
60 seconds.
6. Proceed to the next step, 'Preparing the
Activ360™ Filter'.
PREPARING THE ACTIV360™ FILTER
Flushing the filter is required every time you
insert a new filter cartridge.
FILTER RESET
90d
Filter Reset will flash continuously on the
screen to notify after 90 days or 200L of water
MAX
filtered as an alert that it is time to replace the
filter cartridge.
MIN
NEW FILTER
button once to
13