Remote Control; Operation - Lasko ULTRA AIR T48335 Operating Manual

ASSEMBLY
1. For ease of assembly, lay the Fan down so that the front grill
and control panel are facing up.
2. Assemble the Support Base Halves by interlocking the Tabs on
Support Base A into the Slots on Support Base B. (Figure 1)
Slots
Support
Base B
Figure 1
3. Align the Support Base Assembly with the Motor Base. Make
certain to align the Key on the Support Base Assembly with the
Locating Notch on the Motor Base. Attach the Support Base
Assembly to the Motor Base with Thumb Screws (Figure 2).
Support Base
Assembly
Thumb Screws
Figure 2

OPERATION

This Fan may be operated by the Manual Controls located on front
of the unit (Figure 3) or by the Remote Control (Figure 4).
1. Place the Fan on a firm and level surface.
2. Plug the cord set into a 120 volt outlet.
Be sure that the plug fits tightly into outlet.
When plugs fit loosely into receptacles, they may slip
partially or completely out of the receptacle with only
the slight movement of the attached cord. Recepta-
cles in this condition may overheat and pose a serious
fire hazard; if covered by a curtain or drape, the fire
hazard is even greater.
3. Apply power to the Fan by pushing the Power Button ( ). The
Fan will initially operate in High Speed, speed 3.
4. FAN SPEED: You may now adjust the Fan speed to the desired
level, 3, 2, or 1 by pressing the Fan Speed Button ( ).
5. OSCILLATION: Press the Oscillation Button (
stop the oscillation function.
6. TIMER FUNCTION: This Fan is equipped with a timer. The timer
can be set for 1-8 hours. Continue pressing the Timer Button
( ) to reach the desired time setting. To cancel timer, press
Timer Button ( ) until lights are extinguished.
7. NIGHTTIME FEATURE: Press the Nighttime Button ( ) once
to turn function on. The lights on the Fan will dim 50%. Fan
will run on High (3) for one hour, change to Medium (2) for one
hour, then finally switch to Low (1) until user interacts with Fan.
Nighttime feature does not work with any other function, except
Oscillation. Press any other button to cancel Nighttime feature.
8. After turning the Fan off, unplug the unit from the electrical outlet.
NEW 11/18
MODEL T48335
Support
Base A
Key
Tabs
Figure 3

REMOTE CONTROL

1. Install two "AAA" batteries (not included) as shown in Figure 4.
2. All the functions performed with the Remote Control work
3. Do not mix old and new batteries. Do not mix alkaline, standard
Power Supply
Cord
4. DO NOT DISPOSE OF BATTERIES IN FIRE. BATTERIES MAY
Figure 4
) to start and
3
identically to the Manual Controls.
(carbon-zinc) or rechargeable (nickel- cadmium) batteries.
EXPLODE OR LEAK.
Power Button
Speed Button
Oscillation
Button
Timer Button
Nighttime
Button
Power
Button
Fan Speed
Button
Timer
Button
Oscillation
Button
Nighttime
Button
T48335ES