Dysk Ssd (Pełnowymiarowy) - Dell OptiPlex Small Form Factor Plus 7010 Owner's Manual

Dysk SSD (pełnowymiarowy)
Removing the M.2280 solid-state drive
Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5-inch hard drive
5. Remove the 3.5-inch hard drive
6. Remove the disk-drive
About this task
The following image indicates the location of the M.2280 solid-state drive and provides a visual representation of the removal
procedure.
Steps
1. Remove the screw (M2x3.5) that secures the M.2280 solid-state drive to the system board.
2. Slide and lift the M.2280 solid-state drive from the M.2 card slot on the system board.
Installing the M.2280 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the M.2280 solid-state drive and provides a visual representation of the installation
procedure.
Wymontowywanie i instalowanie modułów wymienianych samodzielnie przez klienta (CRU)
Before working inside your
if applicable.
if applicable.
cage.
computer.
59