Table of Contents
Advertisement
& Case Open
Displays the detection status of the chassis intrusion detection device attached to the motherboard CI
header. If the system chassis cover is removed, this field will show "Yes", otherwise it will show "No". To
clear the chassis intrusion status record, set Reset Case Open Status to Enabled, save the settings to
the CMOS, and then restart your system.
& CPU Vcore/CPU VDDP/DRAM Channel A/B Voltage/+3.3V/+5V/+12V/VCORE SOC
Displays the current system voltages.
ƒ Smart Fan 5
& Monitor
Allows you to select a target to monitor and to make further adjustment. (Default: CPU FAN)
& Fan Speed Control
Allows you to determine whether to enable the fan speed control function and adjust the fan speed.
Allows the fan to run at different speeds according to the temperature. You can adjust
Normal
the fan speed with System Information Viewer based on your system requirements.
(Default)
Allows the fan to run at slow speeds.
Silent
Allows you to control the fan speed in the curve graph.
Manual
Full Speed
Allows the fan to run at full speeds.
& Fan Control Use Temperature Input
Allows you to select the reference temperature for fan speed control.
& Temperature Interval
Allows you to select the temperature interval for fan speed change.
& Fan Control Mode
Lets the BIOS automatically detect the type of fan installed and sets the optimal control
Auto
mode. (Default)
Voltage mode is recommended for a 3-pin fan.
Voltage
PWM mode is recommended for a 4-pin fan.
PWM
& Fan Stop
Enables or disables the fan stop function. You can set the temperature limit using the temperature curve.
The fan stops operation when the temperature is lower than the limit. (Default: Disabled)
& Temperature
Displays the current temperature of the selected target area.
& Fan Speed
Displays current fan speeds.
& Flow Rate
Displays the flow rate of your water cooling system.
& Temperature Warning
Sets the warning threshold for temperature. When temperature exceeds the threshold, BIOS will emit
warning sound. Options are: Disabled (default), 60
& Fan Fail Warning
Allows the system to emit warning sound if the fan is not connected or fails. Check the fan condition or fan
connection when this occurs. (Default: Disabled)
C/140
F, 70
C/158
F, 80
C/176
o
o
o
o
o
- 33 -
F, 90
C/194
F.
o
o
o
Advertisement
Table of Contents
