Cisco MDS 9396V Installing page 7

Hide thumbs Also See for MDS 9396V:

Table of Contents

Installing the Cisco MDS 9396V Switch

Required Equipment

You need the following equipment for this installation:

• Number 2 Phillips screwdriver

• Tape measure and level (to ensure shelf brackets are level)

Installing the Shelf Bracket Kit into a Four-Post EIA Rack

The following figure shows the installation of the shelf bracket kit into a four-post EIA rack.

Figure 3: Installing the Shelf Bracket Kit into an EIA Rack

To install the shelf brackets in an EIA rack, follow these steps:

Step 1

Position a shelf bracket inside the rack-mounting rails as shown in the above figure. Align the screw holes at the front of

the shelf bracket with the holes in the front rack-mounting rail. Then attach the shelf bracket to the front rack-mounting

rail using a minimum of four 12-24 or 10-24 screws.

The bottom hole of the shelf bracket should align with the bottom hole of a rack unit on the rack-mounting

Note

rail (the hole immediately above the 1/2 in. spacing).

Quantity

Installing the Shelf Bracket Kit into a Four-Post EIA Rack

Part Description

Slider brackets

Crossbar

10-32 x 3/8-in. Phillips pan-head screws

12-24 x 3/4-in. Phillips screws

10-24 x 3/4-in. Phillips screws

Installing the Cisco MDS 9396V Switch

Table of Contents