Table of Contents
Advertisement
The Delta volume setting can be used to adjust to
balance the sound level difference between the TV
channel and the HDMI source input. Press the
arrows (up) or (down) to adjust the delta
value for TV speaker volume.
* Note: Delta volume is available when the input
source is set to HDMI or Analogue sources and the
Audio out is set to TV speakers or HDMI sound
system.
Subwoofer out
Settings > Sound > Advanced > Subwoofer out.
Select On/Off to enable/disable Subwoofer output.
Please ensure Subwoofer device is connected to the
TV. For connection, please refer to Connect Devices >
Subwoofer of the manual. Please ensure Subwoofer
being used contains an active amplifier or driver
inside since the output from TV is analogue Pre out.
Height speaker volume
Settings > Sound > Advanced > Height speaker
volume.
Adjust the loudness level of TV height speaker if the
height speaker is available on your TV.
Audio Out Settings
Settings > Sound > Advanced > Audio out.
Set the TV to play the sound on TV or on the
connected audio system.
You can select where you want to hear the TV sound
and how you want to control it.
• If you select TV speakers off, you permanently
switch off the TV speakers.
• If you select TV speakers, the TV speakers are
always on.
With an audio device connected with HDMI CEC,
select HDMI sound system. The TV will switch off
the TV speakers when the device is playing the
sound.
Digital Output Settings
Digital output settings are available for optical and
HDMI ARC sound signals.
Digital out format
Settings > Sound > Advanced > Digital out
format.
Set the audio out signal of the TV to fit the sound
capabilities of the connected Home Theatre System.
• Stereo (uncompressed): If your audio playback
devices have no multichannel sound processing,
select to only output stereo content to your audio
playback devices.
• Multichannel: Select to output multichannel audio
content (compressed multichannel sound signal) or
stereo audio content to your audio playback devices.
• Multichannel (bypass): Select to output Dolby
Digital Plus or DTS content to your audio playback
devices or Home theatre system.
- Make sure your audio playback devices support
Dolby Atmos feature.
- SPDIF output (DIGITAL AUDIO OUT) will be
disabled when streaming Dolby Digital Plus content.
Digital out levelling
Settings > Sound > Advanced > Digital out
levelling.
Adjust the loudness level from device which is
connected to digital audio output (SPDIF) or HDMI.
• Select More to have louder volume.
• Select Less to have softer volume.
Digital out delay
Settings > Sound > Advanced > Digital out
delay.
For some Home Theatre Systems you might need to
adjust the audio sync delay to synchronise the audio
to the video. Select Off if a sound delay is set on
your Home Theatre System.
Digital out offset (Only available when Digital out
delay set to On)
Settings > Sound > Advanced > Digital out
offset.
If you cannot set a delay on the Home Theatre
System, you can set the TV to sync the sound. You
can set an offset that compensates for the time
necessary for the Home Theatre System to process
the sound of the TV picture. You can set the value in
steps of 5ms. Maximum setting is 60ms.
Dolby Atmos Notification
Settings > Sound > Dolby Atmos notification.
Switch On or Off the Dolby Atmos notification when
Dolby Atmos content begins to play on your TV.
41
Advertisement
Table of Contents
