Table of Contents
Advertisement
Available languages
Available languages
TECHNICAL SPECIFICATIONS
SPECIFICATIONS
Lamp Power
Thermostat
Lower Heater
Upper Heater
Grill Heater
Small Grill
Supply Voltage
Technical specifications can be changed without prior notice to improve
product quality.
The values provided with the appliance or its accompanying documents
are laboratory readings in accordance with the respective standards. These
values may differ depending on the use and ambient conditions.
Figures in this guide are schematic and may not be exactly match your
product.
INSTALLATION OF APPLIANCE
Ensure that electrical installation is suitable for operationalising the
appliance. If not, call an electrician and plumber to make necessary
arrangements. Manufacturing firm can't be hold responsible for damages
to arise due to operations by unauthorized people and product warranty
becomes void.
WARNING: It is customer's responsibility to prepare the location the
product shall be placed on and also have power utility prepared.
WARNING: The rules about electrical local standards must be adhered to
during product installation.
WARNING: Check for any damage on the product before installing it. Do
not have product installed if it's damaged. Damaged products pose danger
for your safety.
60 cm Built-In Oven
15W
40-250 / Max °C
1200W
1000W
1000W
Big Grill
2000W
220V-240V 50 Hz
Important Warnings for Installation:
Figure 1
A clearance must be left behind the enclosure where you'll place the appliance
for efficient and good operation. This clearance shouldn't be ignored as it's
required for ventilation system of the appliance to operate.
Right Place For Installation
Product has been designed to be mounted to worktops procured from market. A
safe distance must be left between the product and kitchen walls or furniture.
See the drawing provided on the next page for proper distances. (values in
mm).
•
Used surfaces, synthetic laminates and adhesives must be heat
resistant. (minimum 100°C).
•
Kitchen cupboards must be level with product and secured.
•
If there is a drawer below the oven, a rack must be placed between
oven and drawer.
WARNING: Do not install the product next to refrigerators or coolers. The
heat emitted by the product increases the energy consumption of cooling
devices.
Cooling fan shall take extra steam out and
prevent outer surfaces of appliance from
overheating during operation of oven.
This is a necessary condition for better
appliance operation and better cooking.
Cooling fan shall continue operation after
cooking is finished. Fan shall
automatically stop after cooling is
completed.
English
7
Advertisement
Chapters
Table of Contents
