Advertisement
Adjustment Sleeves
Jam Nuts
TO REMOVE WHEEL FOR REPAIRS
FRONT WHEEL-
1. Block up axle securely.
2. Remove axle cover, retaining ring and
washers to allow wheel removal
3. Repair tire and reassemble.
4. Replace washers and snap retaining
ring securely in axle groove.
5. Replace axle cover.
REAR WHEEL -
1. Block rear axle securely.
2. Remove five (5) hub bolts to allow
wheel removal
3. Repair tim and reassemble.
Replace
and tighten hub bolts securely.
Washers
Retaining j_
j,ng\ I\ ff' %l
Cover
\
J \
lira( ((_
IM_
NOTE: To seal tire punctures and prevent
flat tires due to slow leaks, tire sealant
may be purchased from your local parts
dealer. Tire sealant also prevents tire dry
rot and corrosion.
TO START ENGINE WITH A WEAK
BA'n'ERY
_kCAUTION:
Lead-acid batteries
generate explosive gases. Keep sparks,
flame and smoking materials away from
batteries. Always wear eye protection
when around batteries.
If your battery is too weak to start the
engine, it should be recharged. (See
"BATI'ERY" in the MAINTENANCE
section of this manual).
If "jumpercables"are used for emergency
starting, f ollow thisprocedure:
IMPORTANT: YcdJr tractoris equippedwitha
12 voltnegativegroundedsystorn.The other
vehical must aJso be a 12 volt n egative
grounded system.Do not use yourtractor
batteryto start other vehicles.
TO A'[-i-AC H JUMPER CABLES -
t. Connect each end of the RED cable to
the POSITIVE (+) terminal of each
battery, taking care not to short
against chassis.
2. Connect one end of the SLACK cable
to the NEGATIVE (-) terminal of fully
charged battery.
3. Connect the other end of the BLACK
cable to good CHASSIS GROUND,
away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER -
1. BLACK cable first from chassis and
then from the fully charged battery.
2. RED cable last from both batteries.
"PosCdve"_Negativs"
(+)-----
REPLACING BA'I-I'ERY
ACAUTION:
Do not short battery
terminals by allowing a wrench or any
other object to contact both terminals at
the same time. Before connecting battery,
remove metal bracelets, wristwatch
bands, rings, etc.
Positive terminal must be connected first
to prevent sparking from accidental
grounding.
1. Lift hood to raised position.
2. Remove terminal guard.
3. Disconnect BLACK battery cable then
RED battery cable and carefully
remove battery from tractor.
4. Install new battery with terminals in
same position as old battery.
5. Reinstall terminal guard.
6. Firstconnect RED battery cable to
positive (+) battery terminal with hex
bolt and keps nut as shown. Tighten
securely.
7. Connect BLACK grounding cable to
negative (-J battery terminal with
remaining hex bolt and keps nut.
Tighten securely
8.
Close terminal access doors.
g.
Close hood.
26
Advertisement
