Samsung RS58K6688SL User Manual page 58

Maintenance
NOTE
• A newly installed filter may cause the water dispenser to spurt water briefly. This is
because air has entered the waterline.
• This replacement process may involve the refrigerator to drip water onto the floor. If
this happens, wipe up with dry cloths.
Reverse osmosis water filtration system
The water pressure of the water supply system to a reverse osmosis water filtration
system must be between 35 psi and 120 psi (241 kPa and 827 kPa).
The water pressure of the reverse osmosis water filtration system to the refrigerator's
cold water line must be at least 40 psi (276 kPa). If the water pressure is below the
specified:
• Check to see whether the sediment filter in the reverse osmosis system is blocked.
Replace the filter if necessary.
• Refill the water tank in the reverse osmosis system with water.
• If your refrigerator has a water filter, it may further reduce the water pressure when
used in conjunction with a reverse osmosis system. Remove the water filter.
For more information or servicing, contact a licensed plumbing professional.
Ordering a new filter
To purchase a new water filter, contact a local Samsung service centre.
Lamps and anti-bacteria filter
Neither lamps nor the anti-bacteria filter are user-serviceable. Do not attempt to replace
them yourself. To replace them, contact a local Samsung service centre.
58 English
Untitled-66 58
4. Turn the cartridge knob clockwise to
lock into place.
5. Press and hold Filter Reset on the
feature panel for 3 seconds to reset the
filter lifecycle. The filter indicator (
turns off.
6. When replacing is complete, flush 4
liters of water to remove impurities
from the water line. See the Flushing
section for more information.
)
7/18/2017 4:35:52 PM