Craftsman 917.273392 Owner's Manual page 21

18.0 hp, 42" mower electric start 6 speed transaxle
Table of Contents

Advertisement

CLEANING
• Clean engine, battery, seat, finish, etc.
of all foreign matter.
• Keep finished surfaces and wheels free
of all gasoline, oil, etc.
• Protect painted surfaces with auto-
motive type wax.
We do not recommend
using a garden
hose or pressure washer to clean your
tractor unless the engine and transmis-
sion are covered to keep water out. Water
in engine or transmission
will shorten the
useful life of your tractor. Use compressed
air or a leaf blower to remove grass,
leaves and trash from tractor and mower.
_IL
WARNING:
TO AVOID SERIOUS INJURY, BEFORE PERFORMING
ANY
SERVICE OR ADJUSTMENTS:
1. Depress clutch/brake
pedal fully and set parking brake.
2. Place gearshift lever in neutral (N) position.
3. Place attachment
clutch in "DISENGAGED"
position.
4. Turn ignition key to "STOP" and remove key.
5. Make sure the blades and all moving parts have completely stopped.
6. Disconnect spark plug wire from spark plug and place wire where it cannot
come in contact with plug.
TRACTOR
TO REMOVE MOWER
Mower will be easier to remove from the
right side of tractor.
1. Place attachment
clutch in "DISEN-
GAGED" position.
2. Move attachment
lift lever forward to
lower mower to its lowest position.
3. Roll belt off engine pulley.
4. Remove small retainer spring, and
remove clutch spring off pulley bolt.
5. Remove large retainer spring, slide
collar off and push housing guide out
of bracket.
6. Disconnect anti-sway bar from chassis
bracket by removing retainer spring.
Small
Clutch
Small Retainer Spring-
Clutch Spring----______
7. Disconnect suspension arms from rear
deck brackets by removing retainer
springs.
8. Disconnect front links from deck by
removing retainer springs.
9. Raise lift lever to raise suspension
arms. Slide mower out from under trac-
tor.
IMPORTANT:
If an attachment
other than
the mower deck is to be mounted on the
tractor, remove the front links and hook
the clutch spring Into square hole in frame.
TO INSTALL MOWER
1. Raise attachment
lift lever to its highest
position.
Front Link
Retainer
Anti-Swa_,
Housing
Retainer Springs
Both Sides)
Bracket
Deflector Shield
Large Retainer Spring
21

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents