GE AGH24 Owner's Manual And Installation Instructions page 5

When the air conditioner is turned on, it will
automatically start in the last cool and fan
settings used.
COOL Mode
Use the COOL mode with HIGH (F3), MED (F2) or
LOW (F1) fan for cooling. Use the INCREASE
DECREASE
pads to set the desired temperature
between 60°F and 86°F in 1°F increments.
A thermostat is used to maintain the room
temperature. The compressor will cycle on and off
to keep the room at the set level of comfort. Set the
thermostat at a lower number and the indoor air
will become cooler. Set the thermostat at a higher
number and the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned on
while set to COOL, it will take approximately 3 minutes
for the compressor to start and cooling to begin.
FAN Mode
Use the FAN at HIGH (F3), MED (F2) or LOW (F1) to
provide air circulation and filtering without cooling.
Since fan only settings do not provide cooling,
a temperature setting will not be displayed.
Vent Control
The vent control is located on the inside of the air
louvers on the lower right side.
When set at CLOSE , only the air inside the room will
be circulated and conditioned. When set at OPEN ,
some inside air is exhausted outside.
Air Direction – Up and Down
Fingertip pressure on the bank of horizontal
louvers adjusts the air direction up or down.
Lights next to the touch pads on the air conditioner
control panel indicate the selected settings.
Cooling Descriptions
/
For Normal Cooling – Select the COOL mode and
HIGH (F3) or MED (F2) fan with a middle set
temperature.
For Maximum Cooling – Select the COOL mode
and HIGH (F3) fan with a lower set temperature.
For Quieter & Nighttime Cooling – Select the
COOL mode and LOW (F1) fan with a middle set
temperature.
NOTE: If you switch from a COOL setting to OFF or to
a fan setting, wait at least 3 minutes before switching
back to a COOL setting.
To open the vent, pull the lever toward you.
To close it, push it in.
GEAppliances.com
5