Switchable Graphics In Two Modes(Select Models Only) - Lenovo G470 User Manual

Using passwords
Using passwords helps prevent your computer from being used by others.
Once you set a password and enable it, a prompt appears on the screen each
time you power on the computer. Enter your password at the prompt. The
computer cannot be used unless you enter the correct password.
Note: This password can be from one to seven alphanumeric characters in any combination.
For details about how to set the password, see the Help to the right of the
screen in BIOS setup utility.
Note: To enter BIOS setup utility, press F2 when the Lenovo logo appears on the screen while
the computer is starting up.
Switchable Graphics in two modes
(Select models only)
The Lenovo G-series model supports Switchable Graphics in two modes:
Mode 1 Select the graphics processor based on application needs
In this mode, the system allocates a graphics processor to some applications
automatically. Alternatively, you can also manually select a graphics
processor for your applications.
The default setting of your computer is Mode 1. To switch to Mode 2, please
refer to "Switching between Mode 1 and Mode 2".
Mode 2 Select the graphics processor manually or based on power
source
In this mode, you can select a graphics processor manually or based on the
power source status (AC/DC):
• High-performance GPU: It is also referred to as the independent GPU,
which can provide higher graphics processing and display performance.
• Power-Saving GPU: It is also referred to as the integrated GPU, which can
enable a longer running time of the battery.
Switch between the two graphics processors as follows:
1 Start your computer under the Windows 7 operating system.
→
2 Click Start
CCC.
3 Click Power
setting page.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
All Programs
→
Switchable Graphics on the Catalyst Control Center
Chapter 2. Learning the basics
→
Catalyst Control Center, and run the
23