Note For Multi System - Daikin FTXS50KAVMN Operation Manual

Note for Multi System

Multi system has one outdoor unit connected to multiple indoor units.
Selecting the operation mode
With the priority room setting present but
inactive or not present.
When more than one indoor unit is operating, priority is given to
the fi rst unit that was turned on.
In this case, set the units that are turned on later to the same
operation mode as the fi rst unit.
Otherwise, they will enter the standby state, and the operation
lamp will fl ash: this does not indicate malfunction.
NOTE
Notes on operation mode for multi system
• COOL, DRY and FAN mode may be used at the same time.
• AUTO mode automatically selects COOL mode or HEAT mode based on the room temperature.
Therefore, AUTO mode is available when selecting the same operation mode as that of the room with the fi rst unit to be turned on.
CAUTION
• Normally, the operation mode in the room where the unit is fi rst run is given priority, but the following situations are exceptions, so please keep
this in mind.
If the operation mode of the fi rst room is FAN mode, then using HEAT mode in any room after this will give priority to HEAT. In this situation,
the air conditioner running in FAN mode will go on standby, and the operation lamp will fl ash.
With the priority room setting active.
Refer to "Priority room setting" on the next page.
NIGHT QUIET mode (Available only for COOL operation)
NIGHT QUIET mode requires initial programming during installation. Please consult your retailer or dealer for assistance.
NIGHT QUIET mode reduces the operation noise of the outdoor unit during the nighttime hours to prevent annoyance to
neighbors.
• The NIGHT QUIET mode is activated when the temperature drops 5°C or more below the highest temperature recorded that day.
Therefore, when the temperature difference is less than 5°C, this function will not be activated.
• NIGHT QUIET mode reduces slightly the cooling effi ciency of the unit.
OUTDOOR UNIT QUIET operation
Refer to "OUTDOOR UNIT QUIET operation".
With the priority room setting present but inactive or not present.
When using the OUTDOOR UNIT QUIET operation feature with the Multi system, set all indoor units to OUTDOOR UNIT
QUIET operation using their remote controllers.
When clearing OUTDOOR UNIT QUIET operation, clear one of the operating indoor units using their remote controller.
However OUTDOOR UNIT QUIET operation display remains on the remote controller for other rooms.
We recommend you release all rooms using their remote controllers.
With the priority room setting active.
Refer to "Priority room setting" on the next page.
A room
C room
Page 18
B room
D room
Outdoor unit
28