LG DF20WV Owner's Manual page 45

Before Calling For Service (cont.)
Problem
The display • MORE TIME button pressed.
shows
CHECK FILTER • Lint filter is almost clogged or
light is on full.
during the
drying cycle
TM
FLOW SENSE • Ductwork is too long or has too
indicator many turns/restrictions.
shows four • Significant blockage of the
bars during the ductwork due to lint buildup or
drying cycle debris.
or the display • The appliance has detected a
shows "d80" restriction in the external dryer
after drying.
venting.
The display • The duct work is about 90%-
shows "d90", 95% blocked.("d90" or "d95" error
"d95" code displayed 2 hours only)
• House exhaust system blocked.
Possible Causes Solutions
• This display indicates that the steam option has been set
for a " " item such as a comforter.
Press the LESS TIME button to reduce the indicated load
size.
• Pause the drying cycle and clean the lint filter.
• Install a shorter or straighter duct run. See the Installation
Instructions.
• Ductwork should be checked/cleaned soon.
Dryer can be used in this condition, but drying times may
be longer.
• If exhaust restrictions are sensed by the FLOW SENSE
system, the indicator will remain on for two hours after
the end of the cycle. Opening the door or pressing the
POWER button will turn off the display.
• Do not use the dryer until the exhaust system has
been cleaned and/or repaired. Using the dryer with a
severely restricted exhaust is dangerous and could result
in a fire or other property damage.
• Check the outside dryer vent while the dryer is operating
to make sure there is strong airflow.
• If the exhaust system is extremely long, have it repaired or
rerouted.
• Keep the area around the dryer clean and free of clutter.
• Check vent hood for damage or lint clogging.
• Make sure the area around the vent hood is clear.
TrOuBLESHOOTiNg
TM
45