Intex Ultra Rondo XTR Owner's Manual page 16

SAND FILTER PUMP HOSE CONNECTION SETUP
• Keep this product more than 3.5m away from the pool.
• Keep the plug of this product more than 4m away from the pool and at a
height of 1.2m at least.
• Position this product away from the pool, so as to prevent children from
climbing on it and accessing the pool.
The 6-way valve has three hose connection ports.
1. Connect one hose (12) end to the pre-filter inlet and the other end of the hose to the lower
plunger valve with the strainer. Ensure the hose nuts are securely tightened.
2. Connect the second hose (12) between the 6-way valve water outlet and the upper plunger
valve with the inlet-nozzle. Ensure the hose nuts are securely tighten.
3. The third hose connection port (drain/waste outlet) on the 6-way valve shall be directed to
a proper draining receptacle using a hose or pipe (not provided). Remove the drain cap
before attaching the drain/waste hose or pipe.
4. The sand filter pump is now ready to filter the pool.
WATER
INLET
TO
DRAIN
POWER
CORD
RCD
According to the International Standard, IEC 60364-7-702, on electrical installation of swimming
pools and other basins equipment, the following installation distances must be respected:
• The filter pump must be positioned more than 3.5m away from the pool walls.
• The power cord plug to the 220-240 volt electrical power source of the filter pump must
be positioned more than 4m away from the pool walls.
Check your local authorities to determine the appropriate standard and requirements for
"electrical installation of swimming pools and basins equipment". The following table is for
reference only:
Country/Region
International
Germany
The Netherlands
SAVE THESE INSTRUCTIONS
(342GS) SAND FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U 06/06/2022
WARNING
6-WAY VALVE
WATER
OUTLET
L-SHAPE
O-RING
AIR RELEASE VALVE
MOTOR
PRE-
WATER
FILTER
MOTOR
OUTLET
>4M
France
AIR JET VALVE
INLET THREADED AIR
CONNECTOR
PLUNGER
VALVE
WATER INLET
L-SHAPE
O-RING
>3.5M
(ILLUSTRATION NOT TO SCALE)
Standard Number
IEC 60364-7-702
NF C 15-100-7-702
DIN VDE 0100-702
NEN 1010-702
342
English
GS
WATER LEVEL
ADJUSTABLE
POOL INLET
JET NOZZLE
THREADED
STRAINER
CONNECTOR
OUTSIDE
LINER WALL
Page 15