Table of Contents
Advertisement
Section 3 - Configuration
Go to Features > Firewall, then click the IPv4 Rules tab or the IPv6 Rules tab
to configure rules for traffic filtering.
To configure the Firewall Advanced settings, click the Advanced link. Refer
to Firewall on page 58.
To begin, use the drop-down menu to select whether it is an ALLOW or DENY
rule. You can also choose to turn filtering OFF.
If you want to remove a rule, click
a rule, click
in the Edit column. If you wish to create a new rule, click the
Add Rule button.
If you click Edit or Add Rule, the following options will appear:
Name
Enter a name for the rule.
Source IP
Enter the source IP address range (e.g. 1.1.1.1-1.1.1.2 for IPv4 or
Address Range
2001::1-2001::2 for IPv6) that the rule will apply to. Using the drop-
down menu, specify whether it is a WAN or LAN IP address. Both a
single IP address and a range of IP addresses can be entered.
Destination IP
Enter the destination IP address range (e.g. 1.1.1.1-1.1.1.2 for IPv4 or
Address Range
2001::1-2001::2 for IPv6) that the rule will apply to. Using the drop-
down menu, specify whether it is a WAN or LAN IP address. Both a
single IP address and a range of IP addresses can be entered.
Protocol & Port
Select the protocol of the traffic to allow or deny (Any, TCP, or UDP)
Range
and then enter the range of ports (e.g. 21-23) that the rule will apply
to. Select Any to allow/deny all types of traffic regardless of the port
number.
D-Link M15 User Manual
IPv4/IPv6 Rules
in the Delete column. If you wish to edit
60
Advertisement
Table of Contents
