Fujitsu AO G09LUCB Series Design & Technical Manual page 34

REMOTE CONTROLLER SIGNAL CODE SETTING
„ „
Use the following steps to select the signal code of the remote controller. (Note that
the air conditioner cannot receive a signal code if the air conditioner has not been set
for the signal code.)
1. Press the START/STOP (
controller display.
2. Press the MODE button for at least 5 seconds to display the current signal code
(initially set to ).
3. Press the SET TEMP. (
→ → → .
Match the code on the display to the air conditioner signal code.
4. Press the MODE button again to return to the clock display. The signal code will
be changed.
• If no buttons are pressed within 30 seconds after the signal code is displayed, the system returns to the original
clock display. In this case, start again from step 1.
• The air conditioner signal code is set to A prior to shipment.
/ ) button until only the clock is displayed on the remote
/ ) buttons to change the signal code between
- (01 - 31) -