Poulan Pro PR675Y22RHP Operator's Manual page 12

"THREE POINT" ADJUSTMENT
(18" (45cm) HI-VAC MODELS ONLY)
Both rear wheels are adjusted by a single
lever on the left rear wheel.
• Pull adjuster lever toward wheel. To
raise mower, move lever forward to
desired position. To lower mow er, move
the lever toward the rear.
NOTE: There are seven (7) height adjust-
ment positions for the rear wheels.
Both front wheels are adjusted as follows:
1. Remove wheel, bolt, and hardware and
reassemble in desired ad just ment hole.
2. Reinstall wheel components in the
same order as they were before re-
moval. Tighten securely.
NOTE: There are seven (7) height adjust-
ment holes for the front wheels. Be sure
both front wheels are in the same hole.
IMPORTANT: Be sure to adjust both front
and rear wheels to the same height.
LEVER BACKWARD
TO LOWER REAR
OF MOWER
Lockbar
("locked"
position) Washer
Spacer
Wing nut O-Ring
CASTER WHEEL OPERATION
("THREE POINT" ADJUSTMENT ONLY)
The front wheels can be "locked" into
position or set to "freewheel" for better
maneuverability. Placing the lockbars in
the outer holes of the adjustment brackets
"locks" the front wheels. Likewise, placing
the lockbars in the inner holes of the ad-
justment brackets allows the front wheels
to spin freely ("freewheel").
• Lift lockbar until the frontmost end
clears the adjustment bracket, then
pivot lockbar to desired position.
IMPORTANT: Front wheels must be
"locked" into position when operating on
a slope. Mow across the face of slopes:
never up and down.
OPERATION
Height adjuster lever
LEVER FORWARD
TO RAISE REAR OF
MOWER
Bolt
Lockbar
("freewheel"
position)
TO CONVERT MOWER:
Most mowers are shipped ready to be
used as a mulcher.
"REAR DISCHARGE ONLY" MOWERS
Some models have a seperate mulcher
plug, other models have the mulcher plug
built into the rear door. To convert to bag-
ging or discharging, the plate or plug (if
so equipped) must be removed from the
dis charge open ing of the lawn mower.
• Open rear door and remove mulcher
plate or plug (if so equipped). Store
mulcher plate or plug in a safe place.
• You can now install grass catcher or
optional clipping deflector accessory.
• To return to mulching operation, install
mulcher plate or plug into discharge
opening of mower.
CAUTION: Do not run your lawn
mower without mulcher plate/plug in
place or ap proved clipping deflector or
grass catch er in place. Never attempt to
op er ate the lawn mower with the rear door
removed or propped open.
Slots
Mulcher
plug
MULCHER PLUG BUILT INTO REAR DOOR
12
MULCHER
"PLATE"
Mulcher
plate tabs
MULCHER
"PLUG"