Table of Contents
Advertisement
18 INSTALLATION
3
Connect all the wire harnesses and the
ground wire.
NOTE
• The number of wire harnesses may vary
depending on the model.
4
Push the water supply tube into the hole on
the top case and pull it through the backplate.
5
Hold the water supply connection and gently
push in the collet
supply line as shown. Insert the tube at least
5/8 inch (15 mm) into the connector. Insert
the clip on the joint to fasten the tube in place.
• Connections may vary by model.
† This feature is only available on some
models.
to connect the water
d
†
Type A
†
Type B
NOTE
• Disassembling/Assembling the Water Lines
Collet
Tube
e
f
g
• Gently press the collet and insert the tube until
only one line shows on the tube.
6
Place the cover
i
the cover screw
j
Insert line
Clip
h
in place. Insert and tighten
.
Advertisement
Table of Contents
