Using The Camera In Pir Detection Mode - Stealth Cam WD2IR User Manual

Using the camera in PIR detection mode

•
Mount the camera to tree or other sturdy object using either
supplied tree screw or mounting strap (Please refer to the
mounting suggestions section in this manual)
•
Open the front housing and move the switch to the ON position.
At this point you have 30 seconds to make any program
adjustments.
•
After 30 seconds the camera's green test light will begin
blinking and enter count down mode. This is your indication to
leave the coverage area with one minute.
•
After one minute the camera will take between 1~3 pictures or
a 10 seconds AVI video based on your program setting. The
camera will then time out between 1 ~ 60 minutes also based
on your setting.
The time between motion detection and the camera taking
the pictures may vary due to lighting conditions, program
setting and battery power level.
www.stealthcam.net
STC-WD2-IR
Toll Free 877-269-8490 25