Philips 39PFL3559/V7 User Manual page 15

4.10 Features Menu
Press
1
2 Select [Setup] > [Features]
then press OK
3 Select one of the following settings.
then press OK. .
Press to move, and press
Back Light
Picture Blue Mute
Energy Saving
Sound
EasyLink
Installation
HDMI ARC
MHL
Features
Reset
Parental
[Back Light] : The backlight value
can be varied . This function used to
adjust brightness level of panel.
[Blueback] :This function is used to
ON /OFF the blue screen at no signal
condition.
• [Energy Saving]:
To save
the power consumed by TV, select
power saving modes Off/low/Mid/ High/
Audio only Mode.
After selection of Low/Mid/high energy
saving indication displayed on energy
meter by pressing info key of remote control
Low: After selection of energy saving
option to "Low", approx.5% of rated
power will get saved.
Mid: After selection of energy saving
option to "Mid", approx.10% of rated
power will get saved.
High: After selection of energy saving
option to "High", approx 25% of rated
power will get saved.
Audio only : After selection of energy
saving to "Audio only " panel power
switched off & only audio come
from TV sets which results in
power saved of approx 35%
Note
Press any key ( except Find, Text, subtitle
Vol +/- and Mute) to exit 'Audio only' mode
[EasyLink]: If you connect HDMI-CEC
compliant devices through HDMI,you
can control them at the same time with
your TV remote control.
• [HDMI ARC] : If you connect ARC enabled
Home Theater to TV set HDMI ARC to ON
to listen sound through Home Theater
to adjust.
• [MHL] : To use MHL function set this to ON.
Note
EasyLink Applicable for only HDMI Source.
MHL is supported in HDMI 1.
ARC is supported in HDMI 2, If ARC is set to
on, TV Speaker will be disabled.
• [Reset] : Reset to factory default settings.
4.11 Parental Menu
Picture
Sound
Installation
Features
Parental
Press
1
2 Select [Setup] > [Parental]
then press OK
3 Select one of the following settings.
then press OK.
[Child Lock]: Enter the password, then
the following menus will open.
Note: Default password is "0000"
[Child Lock Switch]:Make the child lock
switch ON to lock the source/channel.
[Video Lock]: Select the sources
with up/down keys on remote and press
OK to set or clear lock.
[Channel lock]: Select the channels to
to be locked and press OK key to lock or
unlock the channels.
[Change Password]: Select this option
to change the password.
• [Clear All]: Reset the child lock
option to default value.
Child Lock
EN 13