Desa VGC24NR Instruction Manual page 17

6.. Install.receiver.bracket.to.base.with.phil-
lips. screws. provided. in. hardware. kit. as.
shown.in.Figure.20.
7. If installed, disconnect AUTO/OFF/ON
switch. wire. from. control. valve. at. TPTH.
and.TH.locations.(see.Figure.21).
8.. Install. remote. receiver. into. receiver.
bracket.using.pads.and.push.button.clips.
provided.with.receiver.(see.Figure.20).
9.. Connect.wires.from.hardware.pack.(with.
remote.receiver.bracket).to.control.valve.
at.the.TPTH.and.TH.locations.as.shown.
in.Figure.21..Connect.other.ends.of.these.
wires.to.remote.receiver.wires.
Note: Make sure excess wire does not
interfere with burner or pilot.
10..If heater was removed from fireplace be-
fore installation of remote accessory, see
Installing Heater Base Assembly.on.page.
12 to reinstall heater into fireplace. Test gas
connection. for. leaks. (see. Checking Gas
f i r e - p a r t s . c o m
Connections, page 15).
Terminal.Wires
Pads
Remote.
Receiver.
Bracket
Push.
Button.
Clips
Figure 20 - Installing Remote Receiver
Bracket
Control.
Valve
Figure 21 - Disconnecting Switch from
Control Valve
119162-01H
INSTALLATION
9-Volt.
Battery
Electronic.Ignitor.
(On.Base.Assembly)
Switch
www.desatech.com
Continued
11..If.logs.were.removed.from.heater.for.install.
remote accessory, replace logs (see In-
stalling Logs, Embers and Lava Rock).
Installing Batteries for Remote Receiver
and Hand Held Remote Control
Two.9-volt.alkaline.batteries.(not.included).are.
required.to.operate.this.heater.with.the.wireless.
hand-held.remote.control.set..One.battery.must.
be.installed.in.the.receiver.and.one.in.the.hand-
held.remote.control.unit.
Note: Only use alkaline batteries.
Installing 9-Volt Battery in Receiver
1.. Locate.back.of.receiver.behind.receiver.
bracket.mounted.on.base.assembly.
2... Locate. the. battery. clip. mounted. on. the.
back.of.the.receiver.(see.Figure.22)..
3.. Slide.a.9-volt.battery.through.the.clip.
.. Attach.the.terminal.wires.to.the.battery.
Terminal.
Wires
Battery.
Clip
9-Volt.Battery
Figure 22 - Installing Battery in Hand-Held
Installing 9-Volt Battery (Not Included) in Hand-
Held Remote Control Unit
1.. Remove. battery. cover. on. back. of. re-
mote.control.unit.
2.. Attach.terminal.wires.to.the.battery..Place.
battery.into.the.battery.housing.
3... Replace. battery. cover. onto. remote.
control.unit..
INSTALLING LOGS, EMBERS AND
LAVA ROCK
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
Battery.Cover
Battery.
Housing
Remote Control Unit
Remote.
Control.
Unit
17