Biostar TP61A Setup Manual page 11

2. Insert the DIMM vertically and firmly into the slot until the retaining
chip snap back in place and the DIMM is properly seated.
Note: If the DIMM does not go in smoothly, do not force it. Pull it all the way out and try again.
B. Memory Capacity
DIMM Socket
Location
DDR3_A1
DDR3_B1
C. Dual Channel Memory Installation
Please refer to the following requirements to activate Dual Channel function:
Install memory module of the same density in pairs, shown in the table.
Dual Channel Status
Disabled
Disabled
Enabled
(O means memory installed; X, not installed.)
Note: The DRAM bus width of the memory module must be the same (x8 or x16)
DDR3 Module
512MB/1GB/2GB/4GB/8GB
512MB/1GB/2GB/4GB/8GB
DDR3_A1
O
X
O
T P 61A
Total Memory
Size
Max is 16GB.
DDR3_B1
X
O
O
9