Internal Drying Function - Panasonic K3 Operating Instructions Manual

Internal Drying Function

„ Internal Drying Operation
When cooling or drying operation stopped, the internally controlled drying process is activated in order to suppress the mold
proliferation inside the unit (airflow passage, fan, heat exchanger). According to the installation environment or operating hours,
mold proliferation or inhibition of mold growth will be changed.
Operating conditions and operating hours
z z
Operates in cooling or dry mode for more than 5 minutes.
When finished, the internal drying operation is started.
Drives for about Max 90 minutes.
The figure at right shows the display during the internal
z z
drying operation.
I f you wish to resume operating during internal drying,
z „z z
press / .
„z z T o stop the internal drying operation
z
Press / .
W hen the internal drying operation finished and
z z zz
stopped, the remote control display shows at right.
NOTES:
The internal drying operation is not activated when connecting other than the wired remote controller (CZ-RTC5B /
z z
CZ-RTC6*).
The internal drying function is not designed to automatically operate even if the wired remote controller (CZ-RTC5B /
z z
CZ-RTC6*) is connected when purchased. If you wish to set to ON, refer to the operating instructions for the wired remote
controller (CZ-RTC5B / CZ-RTC6*).
In case that the cooling or drying operation is less than 5 minutes, the internal drying operation cannot be performed.
z z
Humidity inside the room may sometimes increase during internal drying operation.
z z
When cooling or drying operation stopped, the flap automatically opens and the drying operation is started.
z z
CZ-RTC5B
20:30 (THU)
Performing internal drying
Press [ ] to finish.
[ ]
START
20:30 (THU)
[ ]
START
CZ-RTC6*
[ ]
Press
to finish
9