Stihl MS 251 C-Q Instruction Manual page 8

English
Your chain saw is a one-person saw. Do
not allow other persons to be in the
working area – not even while starting.
Do not start the chain saw if the chain is
in a cut.
Move at least 3 meters away from the
place where the machine was refuelled
and never start the motor in enclosed
spaces.
Lock the chain with the chain brake
before starting – risk of injury due to
rotating chain!
Do not drop-start the engine – start as
described in the Instruction Manual.
During operation
Ensure you always have a firm and safe
footing. Take special care when the bark
is wet – danger of slipping!
Always hold the chain saw firmly with
both hands: Right hand on the rear
handle – even if you are left-handed. To
ensure reliable control, wrap your
thumbs tightly around the handlebar and
handle.
In the event of impending danger or in
an emergency, switch off the engine
immediately by moving the Master
Control lever / stop switch to STOP, 0 or
†.
6
Never let the machine run unattended.
Exercise caution with slippery surfaces,
water, snow, ice, steep slopes, uneven
ground or green wood that has just been
stripped of its bark – danger of slipping!
Use caution with tree stumps, roots,
ditches – danger of stumbling!
Do not work alone – keep within calling
distance of others who are trained in
emergency procedures and can provide
help in an emergency. Helpers at the
cutting site must also wear protective
clothing (helmet!) and stand well clear of
the branches being cut.
More care and attention than usual are
required when wearing ear protection,
as warning sounds (shouts, beeps, etc.)
cannot be heard properly.
Take a break in good time to avoid
tiredness or exhaustion – risk of
accidents!
Dust (e. g., sawdust), fumes and smoke
produced while using the machine may
be hazardous to health. If dust is
generated, wear a dust mask.
When the engine is running: Note that
the saw chain continues to rotate for a
short period after you let go of the
throttle trigger – coasting effect.
No smoking when working with or near
the chain saw - risk of fire! Combustible
fuel vapour may escape from the fuel
system.
Examine the saw chain periodically at
short intervals and as soon as you note
any tangible changes:
Switch off the engine; wait until the
–
saw chain is stationary
Check condition and secure fitting
–
Check sharpness
–
Never touch the saw chain when the
engine is running. If the saw chain
becomes jammed by an object, switch
off the engine immediately before
attempting to remove the object – risk of
injury!
Always turn off the engine before leaving
the machine unattended.
To change the saw chain, switch off the
engine. Risk of injury from the motor
starting unintentionally!
Keep easily combustible materials
(e. g., wood chips, bark, dry grass, fuel)
away from hot exhaust gases and hot
mufflers – risk of fire! Mufflers with
catalytic converters can become
especially hot.
Never work without chain lubrication –
monitor the oil level in the oil tank. Stop
work immediately if the oil level in the oil
tank is too low and top up with chain oil
– see also "Topping up with chain oil"
and "Check chain lubrication".
If the machine is subjected to unusually
high loads for which it was not designed
(e. g., heavy impact or a fall), always
check that it is in good condition before
continuing work – see also "Before
starting work".
Check the fuel system for leaks and
make sure the safety devices are
working properly. Never continue using
MS 251 C-Q