Table of Contents
Advertisement
Reflector Support Straps
Tubes
Gas Line
Burner Observation
Window
Drain Hole
Blower Scroll, Wheel and
Motor
Burner Cup and Orifice
Hot-Surface Igniter
Thermostat
Suspension Points
Decorative and Protective
Grille (optional)
Lower Clearance Shield
(optional)
Wall Tag
Safety Labels
Verify that the reflector support straps are securely clamped to tube and
reflector. See Page 24, Step 6.6.1.
Verify tight and loose screws at reflector overlaps.
Make sure there are no cracks.
Make sure tubes are connected and suspended securely.
See Page 15, Section 6.
Make sure there is no sagging, bending or distortion.
Clean any debris from top of tubes or replace as required.
Check the inside of the firing tube with a flashlight. If carbon or scale are pres-
ent remove the turbulator(s). Scrape out the deposits with a wire brush or rod,
or metal plate attached to a wooden pole and replace turbulator(s) in tube.
Check for evidence of animals such as squirrels or birds and remove any
nests prior to firing.
Check for gas leaks. See Page 43, Section 9.
Make sure it is clean and free of cracks or holes.
Clean and replace as required.
Be sure that the drain hole in the bottom of the burner compartment is not
blocked or clogged.
Compressed air or a vacuum cleaner may be used to clean dust and dirt.
Clear of obstructions (even spider webs will cause problems).
Carefully remove any dust and debris from the burner.
Replace if cracked or broken.
There should be no exposed wire or damage to the thermostat.
See Page 45, Section 10.
Make sure the heater is hanging securely. Look for signs of wear on the chain
or ceiling.
See Page 16, Figure 14.
The grille must be securely attached.
Check that the side reflector extensions are installed correctly and secured in
place if necessary (Decorative grille only).
See Page 32, Section 7 .5 and Page 34, Section 7 .6
Make sure shield is installed correctly and secured in place if necessary.
(Decorative grille only.) See Page 33, Section 7 .5.2.
The lower shield must be securely attached. Inspect shield support straps
and lower clearance shield anchor points. See Page 32, Section 7 .4.
Make sure shield is installed correctly and secured in place if necessary.
See Page 32, Section 7 .4.
If wall tag is present, make sure it is legible and accurate. Please contact
Roberts-Gordon LLC or your ROBERTS GORDON
if you need a wall tag. See Page 4, Section 2.1.
Product safety signs or labels should be replaced by the product user when
they are no longer legible. Please contact Roberts-Gordon LLC or your ROB-
ERTS GORDON
independent distributor to obtain replacement signs or
®
labels. See Page 1, Figure through Page 3, Figure 2.
SECTION 11: O
M
PERATION AND
AINTENANCE
independent distributor,
®
51
Advertisement
Table of Contents
Troubleshooting
