Page 1
INSTRUCTION MANUAL Cordless Driver Drill BDF460 002040 WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
EC Declaration of Conformity ENG104-2 Noise Makita Corporation responsible The typical A-weighted noise level determined according manufacturer declare that the following Makita to EN60745: machine(s): Sound pressure level (L ) : 72 dB(A) Designation of Machine: Uncertainty (K) : 3 dB(A) Cordless Driver Drill The noise level under working may exceed 80 dB (A).
Do not abuse the cord. Never use the cord for representative in Europe who is: carrying, pulling or unplugging the power tool. Makita International Europe Ltd, Keep cord away from heat, oil, sharp edges or Michigan, Drive, Tongwell, moving parts. Damaged or entangled cords Milton Keynes, MK15 8JD, England increase the risk of electric shock.
Page 4
power tool will do the job better and safer at the parts. This will ensure that the safety of the power rate for which it was designed. tool is maintained. 18. Do not use the power tool if the switch does 29.
If operating time has become excessively FUNCTIONAL DESCRIPTION shorter, stop operating immediately. It may result in a risk of overheating, possible burns and even an explosion. CAUTION: If electrolyte gets into your eyes, rinse them Always be sure that the tool is switched off and the •...
Page 6
Reversing switch action Adjusting the fastening torque 1. Reversing 1. Graduations switch lever 2. Adjusting ring 3. Drill marking 4. Pointer 002090 002105 This tool has a reversing switch to change the direction of The fastening torque can be adjusted in 17 steps by rotation.
Then tighten the grip by turning clockwise at the desired When operating overhead, always make sure the • position. It may be swung 360° so as to be secured at battery cartridge is locked securely so that it will not any position.
If you need any assistance for more details regarding 15 minutes before proceeding with a fresh battery. these accessories, ask your local Makita Service Center. MAINTENANCE Drill bits •...
Page 12
Makita Corporation Anjo, Aichi, Japan 884325F224...