Connecting Other Audio/Video Sources To The Recorder - PROTRON PD-DVR100 User Manual

OMPDDVR100.book Page 9 Monday, September 19, 2005 8:35 AM

Connecting Other Audio/Video Sources to the Recorder

There are three audio/video inputs on the recorder, one on the front and two on the rear. Each
has an S-Video input, a composite video input, and a stereo audio input.
In addition, there is a 4-pin IEEE 1394 (i.LINK/FireWire) input on
the front of the recorder.
You can record the video signal from any one of these sources to
DVD.
To connect a digital audio/video (IEEE 1394) source to the
recorder, use an IEEE 1394 cable to connect the device to the
DV IN input on the front of the recorder.
To connect analog audio/video sources to the recorder:
1. Select an audio/video input from the three available on the recorder.
Note: You should use the input on the front of the recorder for non-permanent connections,
such as to a camcorder when transferring its recorded video to DVD.
2. If you would like to use S-Video, which
offers higher quality video than
composite, connect an S-Video cable
(not included) between the video
source and the S-Video input in the
input block selected in step 1 above.
If you would like to use composite
video, connect an RCA cable between
the video source and the Video input in
the input block selected in step 1 above.
3. Using two RCA cables, connect the
audio source to the L (left—white) and
R (right—red) inputs in the input block
selected in step 1 above.
Connecting the Recorder to Other Devices
AUDIO/VIDEO SOURCE
OR
FR
RF IN
S-Video Video R --- Audio --- L
C
IN
1
RF OUT
SR
IN
2
SOURCE INPUT AUDIO OUT
UHF/VHF
9
OUTPUT
S-VIDEO
VIDEO
AUDIO
R
L
FL Y/G
SW Video
Pb/B
Coaxial Optical
S-Video
SL Pr/R
VIDEO OUT DIGITAL AUDIO OUT