Buttons; Connectors - Axis P1375-E User Manual

AXIS P13 Network Camera Series
Specifications

Buttons

Control button
The control button is used for:
• Enabling the Focus Assistant. Press and very quickly release the Control button.
• Resetting the product to factory default settings. See Reset to factory default settings on page 16.

Connectors

Network connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
Audio connector
The Axis product has the following audio connectors:
• Audio in – 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is used from a stereo signal).
• Audio out – 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an active
speaker with a built-in amplifier. A stereo connector must be used for audio out.
3.5 mm audio connectors (stereo)
Audio Input
Audio Output
Illuminator connector
4-pin connector used to connect AXIS Fixed Box Illuminator Kit A to the camera.
I/O connector
Use the I/O connector with external devices in combination with, for example, motion detection, event triggering, and alarm
notifications. In addition to the 0 V DC reference point and power (12 V DC output), the I/O connector provides the interface to:
Digital input - For connecting devices that can toggle between an open and closed circuit, for example PIR sensors, door/window
contacts, and glass break detectors.
Supervised input - Enables possibility to detect tampering on a digital input.
Digital output - For connecting external devices such as relays and LEDs. Connected devices can be activated by the VAPIX®
Application Programming Interface, through an event or from the device's web interface.
1 Tip
Microphone/Line in
Line out (mono)
2 Ring
54
3 Sleeve
Ground
Ground