Table of Contents
Advertisement
3. Connect your USB drive to the TV's USB port.
Important:
your Live TV Pause USB drive to any port, but make sure that nothing is
connected to other USB ports while enabling Live TV Pause. Reconnect other
USB devices after you have finished enabling Live TV Pause.
4. Enable Live TV Pause, as explained in the following topic.
Enabling Live TV Pause
•
After completing a channel scan, select Set up Live TV Pause from the
available options.
•
Press PLAY/PAUSE
•
Highlight the Live TV tile on the Home screen, press STAR on the remote,
and then select Enable Live TV Pause.
After starting setup of Live TV Pause in any of these ways, the TV prompts you
through the steps needed to enable this feature. Setup takes only a few moments.
Note:
Use of a USB hub is not supported.
Using Live TV Pause
If you have used the Roku remote to watch streaming channels, using Live TV Pause
should be very familiar to you.
•
While watching a digital live TV channel, press PLAY/PAUSE
play the content. After the TV program has been paused for 90 minutes, the
TV resumes playing.
•
After watching a channel for a while, press REWIND
point where you first started watching the channel, up to 90 minutes.
•
After pausing or rewinding, press FAST FWD
where you are once again watching the live TV program.
•
Press FAST FWD
skip speeds. Press REPLAY
program.
Some TV models have more than one USB port. You can connect
on the Roku remote while watching a live TV channel.
or REWIND
repeatedly to cycle through 1x, 2x, and 3x
to play back the last several seconds of the
49
to pause or
to jump back up to the
to jump ahead up to the point
Advertisement
Table of Contents
