AEG LAVAMAT 61270 BI User Manual page 16

16 www.aeg.com
• Press the button 8 to set the washing
machine to PAUSE;
• Press the button 9 once until the dis-
play shows the symbol
• Press the button 8 again to start the
programme.
You can change the set delay on-
ly after you set the washing pro-
gramme again.
The Delay Start can not be selected with
DRAIN programme.
9.12 Altering an option or a
running programme
It is possible to change some options
before the programme carries it out. Be-
fore you make any change, you must
press the button 8 to pause the appli-
ance.
Changing a running programme is possi-
ble only by resetting it.
Turn the programme dial to
to the new programme position.
Press the 8 button again to start the new
programme. The washing water in the
tub will not emptied out.
9.13 Interrupting a
programme
Press the button 8 to interrupt a pro-
gramme which is running, the corre-
sponding light starts blinking. Press the
button again to restart the programme.
9.14 Cancelling a programme
Turn the selector dial to
programme which is running. Now you
can select a new programme.
9.15 Opening the door
When the machine is working and
through the delay time, the door is
locked.
If, for any reason, it is necessary to open
it, firstly press the button 8 to set the
machine to pause
If the light B after a few minutes goes
off, the door can be opened.
If the light B stays on and the door re-
mains locked, this means that the ma-
chine is already heating or that the water
level is too high. In this case the door
can not be opened.
If you cannot open the door but you
';
need to open it, turn the programme di-
al to
a few minutes the door can be opened
(pay attention to the water level and
temperature !) .
After closing the door, it is necessary to
set the programme and the options
again. Press button 8 to start the pro-
gramme again.
9.16 At the end of the
programme
The machine stops automatically. The pi-
lot light of button 8, the pilot lights A
and B go off. A blinking
the display.
If you have set a programme or an op-
tion that ends with water in the tub, the
light B remains lit. The door is locked.
The water must be emptied out before
and then
opening the door. During this time the
drum continues to turn at regular inter-
vals until water drain.
Follow the below instructions to empty
out the water:
• Turn the programme selector dial to
• Set the DRAIN or SPIN programme
• Reduce the spin speed, if needed
• Press the button 8
• When the programme has finished the
display shows a blinking
light B goes off. The door can be
opened.
Turn the programme selector dial to
to cancel a
to switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
you do not intend to carry out another
wash, close the water tap. Leave the
door open to prevent the formation of
mildew and unpleasant smells.
Stand by : once the programme has fin-
ished after a few minutes the energy sav-
ing system will be enabled. The bright-
ness of the display is reduced. By press-
ing any button the appliance will come
out of the energy saving status.
to switch the machine off. After
will appear on
. The pilot