Advertisement
Connection options
Wireless
Devices
Visualización de las luces LED
Green steady
Green blinking (2Hz)
POWER
Green blinking (4Hz)
Off
Greed Steady
Green Blinking
DOWNSTREAM
Blue Steady
Off
Greed Steady
Green Blinking
UPSTREAM
Blue Steady
Off
Advertencias de seguridad
WARNING
Risk of electrical shock. Do not expose the device to water or moisture. The device is a high-performance communications device designed for home and office environments. Do not use the device outdoors.
Keep the device in an environment between 0°C ~ 40°C (32°F ~104°F). To avoid overheating, do NOT place any object on top of the device.
Do not restrict the flow of air around the device. The manufacturer assumes no liabilities for damage caused by any improper use of the device.
DISCLAIMER
The manufacturer assumes no liabilities with respect to the contents of this document. The manufacturer also reserves the right to revise this document or update the content there of without any obligation to notify
any person of such revisions or amendments. Specifications subject to change without notice.
CAUTION
The cable distribution system should be grounded (earthed) in a accordance with ANS/NFPA 70, the National Electrical Code (NEC), in particular Section 820.93, Grounding of Outer Conductive Shield of a Coaxial Cable.
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.
FOR MOBILE DEVICE USAGE (>20cm/low power)
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
FOR COUNTRY CODE SELECTION USAGE (WLAN DEVICES)
Note: The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all WiFi product marketed in US must fixed to US operation channels only.
Computers
El dispositivo está alimentado de corriente
eléctrica.
HW initialization.
Fail during POST (Power on self-Test) or error
cause by HW or SW.
No powered.
Downstream frequency locked (One Channel
Only).
The Cable Modem is searching for a
Downstream frequency.
Downstream frequency locked (Channel
Bonding).
Not scanning.
Upstream frequency locked (One Channel
Only).
The Cable Modem is searching for a Uptream
frequency.
Upstream frequency locked (Channel Bonding).
Not scanning.
Phone
Power Adapter
Green Steady
Off
INTERNET
Green Steady
LAN
Off
Green Steady
Green Blinking
(2Hz)
2.4G WiFi/WPS
Red Steady
(During10 seconds)
Off
Green Steady
Green Blinking (1 Hz)
TELÉFONO
Green Blinking (4 Hz)
Green Blinking (4 Hz)
3 veces
Off
Cable
Gateway is operational (Online).
Gateway is offline.
One of the LAN porst is connected as
10/100/1000 Mbps.
No connected devices to LAN port.
2.4 Ghz WiFi is ON
WPS function is active and locking a Wireless
client device to be paired.
Problem with WPS registration.
WiFi if disable by customer.
Phone Line is registerd and ready to make and
recive calls
Phone is off-hook or in use.
New voice mail
3 quick blinks (4 Hz) followed by 3 seconds OFF
means the Line is configured but the VoIP
interface does not have IP . VoIP configuration
error and the ATA is not register to the NGN/SIP .
SIP clients has no active registration and the
line is not active or it is not being able to
register.
COPYRIGHT © 2016 HITRON TECHNOLOGIES, INC.
0440010246N0(1A)
Advertisement
