Frigidaire FGHN2868TP Use & Care Manual page 37

Concern Potential Cause
Dispenser (Ice & Water)
Dispenser will • There is no ice in the bin to
not dispense be dispensed.
ice.
• The refrigerator doors are
not completely closed.
• Dispenser paddle has
been pressed too long and
the dispenser motor has
overheated.
Ice dispenser • Ice has melted and frozen
is jammed. around auger due to
infrequent use, temperature
fluctuations, and/or power
outages.
• Ice cubes are jammed
between ice maker and back
of ice container.
Dispenser will • Water filter not seated
not dispense properly.
water.
• Water filter is clogged.
• Household water line valve is
not open.
Water not • The water dispensing system
cold enough. is not designed to chill water.
Water has • Water has not been
an odd taste dispensed for an extended
and/or odor. period of time.
• Unit not properly connected
to cold water line.
BEFORE YOU CALL
Common Solution
• See the "Ice maker is not making any ice"
section above.
• Be sure the refrigerator doors are
completely closed.
• The motor overload protector will reset in
about three minutes and then ice can be
dispensed.
• Remove ice container, thaw, and empty
the contents. Clean container, wipe dry,
and replace in proper position. When new
ice is made, dispenser should operate.
• Remove ice cubes that are jamming the
dispenser.
• Remove and reinstall the water filter. For
Puresource Ultra II, be sure to rotate it to
the right until it stops and the grip end is
vertical.
• Replace filter cartridge. Be sure to rotate
it to the right until it stops and the grip
end is vertical.
• Open household water line valve. See
CONCERN column AUTOMATIC ICE
MAKER.
• Add ice to cup or container before
dispensing water.
• Draw and discard 10-12 glasses of water
to freshen the supply.
• Connect unit to cold water line that
supplies water to the kitchen faucet.
37