Settings For Motorised Antennas (Diseqc 1.2) - Grundig 40 VLE 8270 WP Manual

speCiAl­settinGs
» KB Frequency (MHz)«: Enter the user
band frequency assigned to the user
band with »1...0« buttons.
» LNB Selection«: If more than one
satellites are used in the current SCR
system, select »1/2« to»2/2« for the
satellite corresponding to the relevant
positions using »
notes:
Use installation equipment supported /
7
suggested by your Multiswitch.
Other users / receivers connected to the
7
system may be affected if the specified user
band number and frequency is changed
during installation.
User band and User band frequency is
7
specified on the Multiswitch used; and
each user / receiver uses a specified user
band and user band frequency.
With SCR satellite system, auto search by
7
several users / receivers at the same time
may cause problems.
– » 22 KHz«: Depending on the LNB type,
22 kHz audio is selected. For a univer-
sal LNB, this option is set to »Auto« and
c annot be changed.
– » DISEqC mode« and »LNB selection«:
depending on the type of antenna used,
< >
use »
« or »
» DiSEqC 1.0« or »DiSEqC 1.1«.
» Off«: for a satellite system with only
one antenna.
» D iSEqC 1.0«: allows up to four satel-
lites to be received simultaneously.
U nder »LNB selection«, use »
>
» « to select the option »1/4«, »2/4«,
»3/4« or »4/4«.
» D iSEqC 1.1«: allows up to 16 satel-
lites to be received simultaneously.
U nder »LNB selection«, use »
>
» « to select the option »1/16« to
»16/16«.
5 Press »menu« to end the setting.
­ - ---------------------------------------------------------------------------------------------------------
< >
« or » « buttons.
« select the option »Off«,
<
<
settings­for­motorised­antennas­
(DiseqC­1.2)
Your television set supports motorised satellite
systems in compliance with DiSEqC 1.2. This
function allows the satellite antenna to be oper-
ated via the television set.
1 Open the menu with »menu«.
2 Select the line »SOURCE SETUP« with »
or » « and press »oK« to confirm.
Λ
– T he »SOURCE SETUP« menu appears.
3 Select the line »DiSEqC 1.2« with »
or » «. Select the option »On« with »
Λ
>
or » «
– T he line »User Mode« is active.
note:
Additional operations are explained in the
7
following sections.
« or
« or
«
v
«
v
<
«
­ 7 1
ENGLISH