Degraded Raid Array - MSI Z270 KRAIT GAMING User Manual

Important
You will lose all data on the RAID drives and any internal RAID structures when you
y
perform this operation.
Possible reasons to Reset Disks to Non-RAID could include issues such as
y
incompatible RAID configurations or a failed volume or failed disk.
Recovery Volume Options
Select option Recovery Volume Options from the main menu screen and press Enter
to change recovery volume mode. The following screen appears:
[ ↑↓] - select
Recovery mode will change from Continuous Update to On-Request after you enable
Only Recovery Disk or Only Master Disk.

Degraded RAID Array

A RAID 1, RAID 5 or RAID 10 volume is reported as degraded when one of its hard
drive members fails or is temporarily disconnected, and data mirroring is lost. As a
result, the system can only utilize the remaining functional hard drive member. To
re-establish data mirroring and restore data redundancy, refer to the procedure below
that corresponds to the current situation.
RAID Volumes
ID Name Level
0 Volume0 RAID 1(Mirror)
Physical Disks:
Port Device Model
1 XXXXXXXXXXXXX
2 XXXXXXXXXXXXX
Press <CTRL-I> to enter Configuration Utility..
Missing Hard Drive Member
1. Power off.
2. Reconnect the hard drive.
[ RECOVERY VOLUME OPTIONS
1. Enable Only Recovery Disk
2. Enable Only Master Disk
HELP
[
Enable Only Recovery Disk - enables recovery disk if available and
disables master disk.
Enable Only Master Disk - enables master disk if available and
disables recovery disk.
Actions will result in change from Continuous Update mode to On-Request.
[ESC] - Previous Menu
Strip Size
N/A XXX.XGB
Serial #
XXXXXXXXXXXXX
XXXXXXXXXXXXX
]
]
[ENTER] - Select
Status Bootable
Degraded Yes
Size Type/Status(Vol ID)
XXX.XGB Member Disk (0)
XXX.XGB Member Disk (0)
101
RAID Configuration