Table of Contents
Advertisement
14
www.aeg.com
option, the indicator of the set
option comes on.
If you set something
incorrect, the display shows
the message Err.
10.6 Starting a programme
without the delay start
Press button Start/Pause to start the
programme.
The relevant indicator stops to flash and
stays on.
The programme starts, the door is
locked. The display show the indicator
.
The drain pump can operate
for a short time when the
appliance fills water.
10.7 Behaviour of the
appliance
After approximately 15
minutes from the start of the
programme:
• The appliance adjusts
• The display shows the
10.8 Starting a programme
with the delay start
1. Press button Zeitvorwahl again and
again until the display shows the
delay you want to set.
2. Press button Start/Pause.
The appliance starts the countdown of
the delay start.
When the countdown is completed, the
programme starts automatically.
Before you press button
Start/Pause to start the
appliance, you can cancel or
change the set of the delay
start.
automatically the cycle
time to the laundry you
have put in the drum to
have perfect washing
results in the minimum
necessary time.
new time value.
10.9 Cancelling the delay start
To cancel the delay start:
1. Press button Start/Pause to set the
appliance to pause.
The related indicator flashes.
2. Press button Zeitvorwahl repeatedly
until the display shows .
3. Press button Start/Pause again to
start the programme immediately.
10.10 Interrupting a
programme and changing a
option
You can change only some options
before they operate.
1. Press button Start/Pause.
The related indicator flashes.
2. Change the option set.
3. Press the button Start/Pause again.
The programme continues.
10.11 Cancelling a running
programme
1. Turn the programme knob to Stop
position to cancel the programme.
2. Turn again the programme knob to a
new washing programme. At this
time you can also set the available
functions.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
10.12 Opening the door when
the programme operates
CAUTION!
If the temperature and level
of the water in the drum are
too high, the door lock
indicator
you cannot open the door.
To open the door proceed as follows:
1. Press the button Ein/Aus for some
seconds to deactivate the appliance.
stays on and
Advertisement
Table of Contents
