Gigabyte GA-Z87X-UD3H User Manual page 69

C-2. Configuring Legacy RAID ROM
Enter the Intel legacy RAID BIOS setup utility to configure a RAID array. Skip this step and proceed with the
®
installation of Windows operating system for a non-RAID configuration.
Step 1:
After the POST memory test begins and before the operating system boot begins, look for a message which says
"Press <Ctrl-I> to enter Configuration Utility" (Figure 9). Press <Ctrl> + <I> to enter the RAID Configuration Utility.
Intel(R) Rapid Storage Technology - Option ROM - 12.0.0.1783
Copyright(C) 2003-13 Intel Corporation. All Rights Reserved.
RAID Volumes :
None defined.
Physical Devices :
ID Device Model Serial #
0 ST3120026AS 3JT354CP
1 ST3120026AS 3JT329JX
Press <CTRL - I> to enter Configuration Utility..
Step 2:
After you press <Ctrl> + <I>, the MAIN MENU screen will appear (Figure 10).
Create RAID Volume
If you want to create a RAID array, select Create RAID Volume in MAIN MENU and press <Enter>.
Intel(R) Rapid Storage Technology - Option ROM - 12.0.0.1783
Copyright(C) 2003-13 Intel Corporation. All Rights Reserved.
1. Create RAID Volume
2. Delete RAID Volume
3. Reset Disks to Non-RAID
RAID Volumes :
None defined.
Physical Deivces :
ID Device Model
0 ST3120026AS
1 ST3120026AS
[hi]-Select
Size
111.7GB
111.7GB
Figure 9
[ MAIN MENU ]
[ DISK/VOLUME INFORMATION ]
Serial # Size
3JT354CP 111.7GB
3JT329JX 111.7GB
[ESC]-Exit
Figure 10
- 69 -
Type/Status(Vol ID)
Non-RAID Disk
Non-RAID Disk
4. Recovery Volume Options
5. Acceleration Options
6. Exit
Type/Status(Vol ID)
Non-RAID Disk
Non-RAID Disk
[ENTER]-Select Menu
Configuring SATA Hard Drive(s)