Yale SAA8031 User Manual

EMC Alarm processing Microprocessor
controlled dual edge sequential pulse
Tested to ETS 300 683
count with pulse length discrimination
Radio Components tested to EN
Radio 433.92MHz AM transmitter
300 220-1
Power supply 4.5V, 3 x AA alkaline cells.
3 years typical domestic service life, 1-
Environmental conditions
minute sleep timer
-10°C to 40°C, relative humidity
Movement detection range 15m, 110°
70% non-condensing for all units
Door/window contact
except the external siren. Siren: -20°C
to 50°C, relative humidity 95% non-
Radio Microprocessor controlled
condensing
433.92MHz AM transmitter
Power supply 3V, 2 x AAA alkaline cells. 3
Radio operational range
years typical domestic service life
30m in a typical domestic
Smoke detector
installation, range can vary depending
on building construction, device
Radio Microprocessor controlled
positions and RF environment
433.92MHz AM transmitter
Housings ABS/polycarbonate Power supply 6V, 4 x AAA alkaline cells. 3
years typical domestic service life
Siren
Keyfob remote control
Siren output 104dBA sound pressure @
1m minimum Radio Microprocessor controlled
Radio 433.92MHz AM super heterodyne 433.92MHz AM transmitter
Power supply 12V, 23A/MN21 alkaline
receiver with jamming detection
miniature "lighter" battery. 3 years
Power supply 6V, 4 x D alkaline cells. 3
years typical service life typical domestic service life
Keypad remote control
Radio Microprocessor controlled
433.92MHz AM transmitter
18
Help button
EMC Tested to EN 300 220-1 and ETS
300 683
Environmental conditions -10°C to
40°C, relative humidity 70% non-
Troubleshooting
condensing
Radio operational range 30m in a
typical domestic installation. Can vary
The units red LED does not flash when the batteries are installed
depending on building construction and
Ensure the batteries are connected correctly according to the
RF environment
Radio Microprocessor controlled
diagram in the battery compartment.
433.92MHz AM transmitter
Power supply 12V 23A/MN21 alkaline
The red light keeps flashing
miniature 'lighter battery'. 3 years
typical domestic service life
This is the 'low battery' indicator. Replace the unit's batteries.
Factory reset
If you forget your PIN or the system malfunctions, you can press the reset
button (locates behind battery cover) to erase all memory. Please ensure
the device is powered and system is in Disarm mode. After reset you will
need to set-up your PIN again and pair with other devices (if required).
Battery precautions
When using this product follow these precautions at all times;
• Use only the appropriate size batteries
• Be sure to follow the correct polarity when installing the batteries as
indicated in the battery compartment. Incorrect polarity may cause
damage to the unit
• Do not mix old and new batteries
• If the alarm is not used for long periods of time, remove the batteries to
prevent damage to the unit or injury from possible battery leakage
• Do not recharge batteries not intended to be recharged. Always
follow the manufacturers directions
• Please only use alkaline batteries
Wireless range
If using as part of an extended system the range of these parts is a
minimum of 1 meter, up to a maximum of 25 meters.
System activity
Please note, when the red light is on the product is processing, so no
operation will work (for example, you will not be able to enter your PIN)
0560
WEEE
Note: Waste electrical products should
not be disposed of with household
waste. Please recycle where facilities School Street, Willenhall,
exist. Check with your local authority or
West Midlands WV13 3PW
retailer for recycling advice.
Tel: +44 (0) 1902 364606
Fax: +44 (0) 1902 364692
email: info@yale.co.uk
SAA8031
Wirefree remote control
Yale
User Manual
Keep this manual safe for future reference
www.yale.co.uk
ARM
CLR