Table of Contents
Advertisement
The speed of continuous shooting decreases when the buffer memory of your device becomes full.
2.
Focus mode
Single-shot AF: Use [Single-shot AF] when the subject is motionless. Touch and hold the screen shutter button or
press the device shutter button halfway down to focus on a subject. The focus remains locked until you release your
finger from the screen shutter button or stop pressing the device shutter button halfway down.
Continuous AF: Use [Continuous AF] when the subject is in motion. The camera continues to focus while you touch
and hold the screen shutter button or press the device shutter button halfway down.
Manual Focus: Adjusts the focus manually using the slider that is displayed beside the [Lock] switch. You can also
tap
(Focus near icon) or
using auto focus, use manual focus.
When you select [Manual Focus], you can magnify the image and adjust the focus by tapping [Focus mag.] on the
focus mode selection screen.
3.
Focus area
Wide: Automatically focuses on the whole range of the screen.
Center: Automatically focuses on a subject in the center of the image.
4.
Exposure value
Adjusts the exposure value in the Shutter speed priority (S) mode and Manual exposure (M) mode using the dial.
5.
ISO sensitivity
Sets the ISO sensitivity automatically (AUTO) or manually. Sensitivity to light is expressed by the ISO number
(recommended exposure index) using the dial. The larger the number, the higher the sensitivity.
6.
Metering mode
Multi: Measures light on each area after dividing the total area into multiple areas and determines the proper
exposure of the entire screen (Multi-pattern metering).
Center: Measures the average brightness of the entire screen, while emphasizing the central area of the screen
(Center-weighted metering).
Spot: Measures only inside the metering circle.
7.
Flash mode
Auto / Fill flash / Red-eye reduction / Off / Flashlight
8.
Creative look
ST / NT / VV / FL / IN / SH: Optimized with a different combination of color tone, saturation, contrast, sharpness,
brightness, and other image elements, so you can set up image processing with your ideal balance of these
elements. For details about each preset look, tap
9.
White balance
Auto / Cloudy / Daylight / Fluorescent / Incandescent / Shade: Adjusts the color tones according to the selected
light source that is illuminating the subject (preset white balance). To finely adjust the color tones, tap [Adjust] to
display the fine adjustment screen, and then move the orange dot to the desired position. After adjusting, tap
(Close button).
Temp 1 / Temp 2 / Temp 3: Memorizes white balance settings defined in terms of color temperature. Tap [Adjust] to
adjust the color temperature using the dial, and then tap [Adjust] to finely adjust the color tone using the fine
adjustment screen. After adjusting, tap
(Focus far icon) to make finer adjustments. If you cannot focus on the intended subject
(Show details button).
(Close button).
85
Advertisement
Table of Contents
