Sony Ericsson T60c Supplementary Manual page 5

Windows 98 or Windows ME Using DRS-11
1 If you plan to use a high-speed serial port, install
and configure it now according to the
manufacturer's directions. Make sure the speed is
set to
230400 bps
2 Shut down Windows and turn off your PC.
3 Connect your computer to your phone. The cable
has a plug on one end that matches the receptacle
on the bottom of your mobile phone. The other
end of the cable has a 9-pin female connector that
matches the standard 9-pin serial interface port
connector. Connect one end of the cable to your
mobile phone and the other end to the serial port
on your computer.
4 Make sure the phone is turned on.
5 Turn on the PC. The PC should detect your phone
as "new hardware" and automatically launch the
Add New Hardware wizard. If it does not, you
must manually setup the T60c. See "Manually
Installing T60c Modem Drivers" on page 7.
6 The next step depends on the operating system
installed on your PC.
AE/LZT 123 2489 R1
.
• If you are running Windows 98 Second Edition
(SE), select Search for the best driver for your
device and click Next.
• If you are running Windows ME, select Specify
location of the driver and click Next.
7 Check Specify a location.
8 Click the Browse button and navigate to the
directory where you downloaded the T60c drivers.
Click OK to proceed.
9 Click Next. Windows displays a window indicating
that it found the (best) driver for the device. Click
Next.
10 Windows finishes installing the modem. Click
Finish when prompted.
11 Set up your data access software according to the
instructions supplied with it. Look for
T60c Data Fax Modem in modem list when
configuring software which will access the handset
as a modem.
ricsson
E
5