Table of Contents
Advertisement
3 Faults – what to do?
B efore you call customer service, use this table to check whether you can rectify the fault yourself.
F a u l t s – w h a t t o d o ?
Appliance
Temperature differs greatly from the set value.
Displays do not light up.
The power plug has not been inserted properly.
The fuse has tripped.
The power has failed.
Display indicates E....
The electronics have detected an error.
The alarm off button flashes and a warning signal sounds.
Door or drawer is open.
Ventilation openings have been covered.
The temperature in the freezer compartment is too warm.
Appliance is not cooling, display and lighting are lit.
Showroom mode switched on.
--------
Switch off appliance for 5 minutes.
~ "Switching off and disconnecting the appliance" on page 20
If the temperature is too warm, check temperature again after a cou-
ple of hours.
If the temperature is too cold, check temperature again on the follow-
ing day.
Connect the power plug.
Check the fuses.
Check whether the power is on.
Please contact customer service.
~ "Customer service" on page 33
Press alarm off button. Alarm is switched off.
Close door or drawer.
Clear the ventilation openings.
Check that the cause of the temperature alarm has been eliminated.
Press alarm off button.
Start the appliance self-test.
~ "Appliance self-test" on page 33
When the program has ended, the appliance switches over to normal
operation.
Faults – what to do? en-us
31
Advertisement
Table of Contents
