Table of Contents
Advertisement
FIREPLACE INSTALLATION
Continued
4. Remove three screws from deflector shield on the inside top
of firebox. Set shield and screws aside.
5. Install rear brick panel first. Rest bottom edge of panel on back
edge of grate (see Figure 43).
6. Install left side brick panel by sliding it between the grate and
the side of the firebox (see Figure 44).
7. Install the right brick panel using the same method described
8. Replace deflector shield using screws removed in step 4.
9. Follow instructions on page 24 to install logs, lava rock, and
ember material.
10. Close glass door, lock latches on top and bottom of door and
replace screen (see steps 5 and 6 of Removing/Replacing Glass
Door, page 22).
11. Close top and bottom louvers.
Rear Brick Panel
Figure 43 - Installing Rear Brick Panel
Left Side
Brick Panel
Figure 44 - Installing Side Brick Panels
For more information, visit www.desatech.com
For more information, visit www.desatech.com
111986-01A
FIREPLACE INSTALLATION
Installing Optional Brick Liner Model BL32D
Installing Logs, Lava Rock and Glowing Embers
INSTALLING LOGS, LAVA ROCK AND
GLOWING EMBERS
Each log is marked with a number. These numbers will help you
identify the log when installing. It is very important to install these
logs exactly as instructed. Do not modify logs. Only use logs
supplied with fireplace.
Open louvers, remove screen, unlock door latches, and open glass
door. See steps 1 and 2 of Removing/Replacing Glass Door, page 22.
Install logs according to instructions for fireplace model numbers.
1. Place log #1 (rear log) on top of grate. Make sure the notches
in the bottom of the log fit over the grate (see Figure 45).
2. Rest log #2 (large front log) on the pins on the front part of the grate
(see Figure 46).
Figure 45 - Installing Log No. 1
Figure 46 - Installing Log No. 2
23
23
Advertisement
Table of Contents
